Overview
This document provides a detailed guide on how to replace the Galvanic Oxygen Sensor Series 3500.
개요
본 문서에서는 Galvanic Oxygen Sensor Series 3500의 교환 방법에 대해 자세히 설명합니다.
Replacement Procedure
교환 절차
Close the Oxygen Sensor Valve: Before replacing the sensor, close the Oxygen Sensor Valve.
Oxygen Sensor Valve 잠그기: 센서 교체 전에 Oxygen Sensor Valve를 잠급니다.
Remove the bolts: Using a Phillips head screwdriver, remove the 4 bolts that secure the sensor.
볼트 제거: 십자 드라이버를 사용하여 센서를 고정하는 볼트 4개를 풉니다.
Disconnect the communication cable: Disconnect the communication cable connected to the sensor.
통신선 분리: 센서와 연결된 통신선을 분리합니다.
Remove the sensor mounting bolts: Using a 9/64 wrench, remove the 3 bolts that secure the sensor.
센서 고정 볼트 제거: 9/64 렌치를 사용하여 센서를 고정하는 볼트 3개를 풉니다.
Replace the sensor: Carefully replace the old sensor with a new one, paying attention to the sensor orientation.
센서 교체: 센서 방향에 주의하여 새 센서로 교체합니다.
Reassemble: Reassemble the sensor in the reverse order of disassembly.
조립: 분해와 역순으로 센서를 조립합니다.
Precautions
Pay attention to the sensor orientation when installing the sensor.
Be careful not to let the O-Ring fall out when installing the sensor.
Check the communication cable connection.
Check that the Oxygen Valve is open.
주의 사항
센서 장착 시 방향에 주의합니다.
센서 장착 시 O-Ring이 빠지지 않도록 주의합니다.
통신선 연결을 확인합니다.
Oxygen Valve가 열려 있는지 확인합니다.
Additional Information
For safety reasons, it is recommended that a qualified technician perform the sensor replacement.
After replacing the sensor, check that the sensor is functioning properly.
For inquiries regarding sensor replacement, please contact dawoovac@dawoovac.com or 042-936-1415.
추가 정보
센서 교체 작업은 안전을 위해 전문가가 수행하는 것이 좋습니다.
센서 교체 후에는 센서가 정상적으로 작동하는지 확인합니다.
센서 교체 관련 문의는 dawoovac@dawoovac.com 또는 042-936-1415로 연락 주시기 바랍니다.